Grom Audio Toyota Microphone Mount
© Mark Qvale - October, 2018
| |
Introduction
I bought a Grom Audio bluetooth module for my 2007 Toyota 4Runner and while the unit itself is excellent, I decided I didn't like the microphone mount. I've installed similar microphone mounts in the past and always found them to be unreliable, especially where I live in Southern Nevada where we see inside temperatures of 150 degrees F (65C) or more as a common occurrence in the summer. Simply put, the double sided tape just disintegrates.
This then is a small project to crate a 3D print part to mount the microphone in a more permanent piece with a more "factory" look.
Part Design
I modeled the part after one of the blank snap-in switch covers. The microphone slides into the back of the piece and is held in by a slight interference fit and a couple tiny dabs of hot glue which also makes it easily removable. It is angled up 15 degrees so that it is essentially pointed at the driver
|
Blank switch cover and printed part |
|
|
Part sketch |
Print Setup
This piece, as shown, is printed in black ABS at a print resolution of 0.1mm. It is sliced and printed on its side with a support structure set up as follows:
- Slicer - Cura
- Overhang Angle - 70°
- Support infill - 24%
Here is a picture of how it looks in Cura:
| 700px | Sliced view |
See Also
3D Print File
Comments? Questions?
