RunCam Split Camera Case
From ItsQv
Revision as of 22:18, 1 December 2017 by WikiSysop (Talk | contribs) (Created page with "<!--Current Parts Catalogs<br>--> <i><small>© Mark Qvale - November, 2017</small></i><br> {| cellspacing="1" cellpadding="1" widt...")
© Mark Qvale - November, 2017
| |
Introduction
After picking up a Runcam Split camera I decided to create a case so that I can easily move the camera from plane to plane. This article then shows three versions of this case. It includes a snap on/off cover over the SD Card to make it easy to access and an internal guard around the microphone to cut down on wind noise.
Versions
The three versions are shown below. They all use the same top cover.
|
You will need to have an M3 tap to set-up the top and bottom.
|
Print Parts
| Image | Part Number | Part Description | Weight | Print File | Drawing | Compatibility |
|
52067 | RunCam Split PCB Top Cover | 6g | 52067.STL | 52067_Sketch | Fits RunCam Split V1 |
|
52076 | RunCam Split SD Card Snap Cover | 6g | 52076.STL | 52076_Sketch | Fits 52067 Cover. |
|
52086 | RunCam Split PCB Cover Bottom, Extended Mount | 6g | 52086.STL | 52086_Sketch | Fits RunCam Split V1 |
|
52087 | RunCam Split PCB Cover Bottom, Integrated Mount | 7g | 52087.STL | 52087_Sketch | Fits RunCam Split V1 |
|
52088 | RunCam Split PCB Cover Bottom, Standard Mount | 7g | 52088.STL | 52088_Sketch | Fits RunCam Split V1 |
See Also
- TBA
Project 3D Print Files
This project can also be found on Thingiverse - [https://www.thingiverse.com/thing:2537982
Comments? Questions?
- <u>email me!
