Dynamic Motor and Prop Balancer
From ItsQv
Revision as of 21:43, 1 November 2017 by WikiSysop (Talk | contribs) (Created page with "== Introduction == This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two link...")
Introduction
This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two links:
Basically, this is a dynamic balancer for motors and props that can be built for under $50. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.
Parts
Purchase Parts
- Teensy USB Board, Version 3.2
- 3-Axis ADXL345 Digital Acceleration Module
- QEE123 - Plastic Infrared Light Emitting Diode
- QSE159 - Silicon Photosensor
- 56 ohm 1/4 watt resistor
- 100 ohm 1/4 watt resistor
- 10K ohm 1/4 watt resistor
- 50mm x 70mm Hobby Board
- Pin Header
Make Parts
- Motor Mount Plate
- Photo Sensor Mount