Difference between revisions of "Dynamic Motor and Prop Balancer"
From ItsQv
(→Make Parts) |
(→Purchase Parts) |
||
Line 29: | Line 29: | ||
:* [https://www.digikey.com/product-detail/en/fairchild-on-semiconductor/QEE123/QEE123-ND/187428?WT.srch=1&gclid=CjwKCAjwj8bPBRBiEiwASlFLFbqn1g5WbYDyYm6zloPYUwDgSuAcsWjYZ1zAKtbzLKXsS6YKSeX5JhoCgdMQAvD_BwE QEE123 - Plastic Infrared Light Emitting Diode] | :* [https://www.digikey.com/product-detail/en/fairchild-on-semiconductor/QEE123/QEE123-ND/187428?WT.srch=1&gclid=CjwKCAjwj8bPBRBiEiwASlFLFbqn1g5WbYDyYm6zloPYUwDgSuAcsWjYZ1zAKtbzLKXsS6YKSeX5JhoCgdMQAvD_BwE QEE123 - Plastic Infrared Light Emitting Diode] | ||
:* [https://www.digikey.com/product-detail/en/fairchild-on-semiconductor/QSE159/QSE159-ND/187485 QSE159 - Silicon Photosensor] | :* [https://www.digikey.com/product-detail/en/fairchild-on-semiconductor/QSE159/QSE159-ND/187485 QSE159 - Silicon Photosensor] | ||
+ | :* 100g Gimbal cushions | ||
:* 56 ohm 1/4 watt resistor | :* 56 ohm 1/4 watt resistor | ||
:* 100 ohm 1/4 watt resistor | :* 100 ohm 1/4 watt resistor |
Revision as of 23:20, 1 November 2017
This page or section is under construction and will change going forward.
Questions or Comments? Please contact the Wiki administrator |
© Mark Qvale - November, 2017
A new tool! |
Introduction
This project was actually done some years ago by some great posters on RCGroups and DoItYourselfDrones. You can read the original threads at these two links:
Basically, this is a dynamic balancer for motors and props that can be built for under $50. In the original write-ups there are two versions of the control board and firmware but this build only covers the version that uses the Teensy micro-controller.
Parts
Purchase Parts
- Teensy USB Board, Version 3.2
- 3-Axis ADXL345 Digital Acceleration Module
- QEE123 - Plastic Infrared Light Emitting Diode
- QSE159 - Silicon Photosensor
- 100g Gimbal cushions
- 56 ohm 1/4 watt resistor
- 100 ohm 1/4 watt resistor
- 10K ohm 1/4 watt resistor
- Standard Red LED
- 50mm x 70mm Hobby Board
- Pin Headers
Make Parts
- Photo Sensor mount
- Cushion Bases
- Balance platform
- Motor mount plate
- Teensy control board
- Wood base
Wiring