Difference between revisions of "FPV Video Transmitter Case"
From ItsQv
| Line 5: | Line 5: | ||
|- | |- | ||
| align="left" valign="bottom" width="50%" | __TOC__ | | align="left" valign="bottom" width="50%" | __TOC__ | ||
| − | | align="right" width="50%" | [[File:VTX_Case. | + | | align="right" width="50%" | [[File:VTX_Case.JPG|600px]] |
|} | |} | ||
Revision as of 20:42, 19 October 2016
August 2014
Contents |
|
Introduction
This simple video transmitter case houses the 400mw & 800mw 1.2G Tx's found at many RC sellers. One such seller is ReadyMadeRC.com. These transmitters come enclosed in a very heavy aluminum heat-sink case which can be discarded.
Simply cut a rectangle in the wing or fuse foam and glue the case in so the cover is flush. Tap the corner holes for a 2mm screw and you are ready to go. You can also add a pair of lightweight 22mm square heat-sinks (see picture) which only add about 8g.
