Difference between revisions of "Brushless Roll Gimbal"

Revision as of 22:44, 26 November 2018

© Mark Qvale - November, 2018

Contents 1 Introduction 2 Print Parts 3 Typical Assemblies 3.1 Details 3.2 Mini Talon Forward Mount 3.3 Stratosurfer Low Profile Mount 4 See Also 4.1 Comments? Questions?

Introduction

In this catalog of parts are components needed to make a brushless single axis roll gimbal. There are notes on compatibility and some pieces with sketches for more information. This roll gimbal fits both my Mini Talon & Stratosurfer canopies as well as any other flat plate mount.

Print Parts

Image	Part Number	Part Description	Print File	Drawing	Compatibility
	52083	Roll Mount Upright	52083.STL	52083_Sketch	Fits canopies for Mini Talon and Stratosurfer. See part sketch for mount hole spacing.
	52013	Motor mount, 16mm	52013.STL	52013_Sketch	Fits motors with 16mm bolt circle
	52187	Motor mount, 12mm	52187.STL	52187_Sketch	Fits motors with 12mm bolt circle
	52011	Camera plate	52011.STL	52011_Sketch	Supports Mobius, Mini Mobius, RunCam, Runcam Split, etc.
	10036	Upright brace, long	10036.STL	10036_Sketch	Fits Mini Talon rear mount canopy
	10037	Upright brace, Short	10037.STL 10037.STL	10037_Sketch	Fits Mini Talon front mount canopy
	10038	Upright brace, Stratosurfer	10038.STL	10038_Sketch	Fits Stratosurfer long LP canopy
	52184	Upright tilt plate, 4 degree	52184.STL	52184_Sketch	Fits all 4-bolt canopy mounts

Typical Assemblies

Details

Mini Talon Forward Mount

Stratosurfer Low Profile Mount

See Also

• Parts Catalog - General Parts
• Parts Catalog - Mini Talon
• Parts Catalog - Strix Stratosurfer
• Parts Catalog - Pan and Tilt Parts

Comments? Questions?

• email me!