Difference between revisions of "RunCam Split Camera Case"

Latest revision as of 13:50, 18 March 2018

© Mark Qvale - November, 2017

Contents 1 Introduction 1.1 Versions 1.2 Print Parts 2 See Also 2.1 Project 3D Print Files 2.2 Comments? Questions?

Introduction

After picking up a Runcam Split V1 camera I decided to create a case so that I could easily move the camera from plane to plane. This article then shows three versions of this case. It includes a snap on/off cover over the SD Card to make it easy to access and an internal guard around the microphone to cut down on wind noise.

NOTE: This was modeled to fit the V1 camera but you can also use it on the V2 version with a slight dremel tool modification.

Versions

The three versions are shown below. They all use the same top cover.

You will need to have an M3 tap to set-up the top and bottom.

Print Parts

Image	Part Number	Part Description	Weight	Print File	Drawing	Compatibility
	52067	RunCam Split PCB Top Cover	4.3g	52067.STL	52067_Sketch	Fits RunCam Split V1
	52076	RunCam Split SD Card Snap Cover	0.7g	52076.STL	52076_Sketch	Fits 52067 Cover.
	52086	RunCam Split PCB Cover Bottom, Extended Mount	4.6g	52086.STL	52086_Sketch	Fits RunCam Split V1
	52087	RunCam Split PCB Cover Bottom, Integrated Mount	4.5g	52087.STL	52087_Sketch	Fits RunCam Split V1
	52088	RunCam Split PCB Cover Bottom, Standard Mount	3.1g	52088.STL	52088_Sketch	Fits RunCam Split V1

See Also

TBA

Project 3D Print Files

This project can also be found on Thingiverse - RunCam Split Simple Case & Mount

<u>email me!