Difference between revisions of "RunCam Split Camera Case"

Revision as of 22:21, 1 December 2017

© Mark Qvale - November, 2017

Contents 1 Introduction 1.1 Versions 1.2 Print Parts 2 See Also 2.1 Project 3D Print Files 2.2 Comments? Questions?

Introduction

After picking up a Runcam Split camera I decided to create a case so that I can easily move the camera from plane to plane. This article then shows three versions of this case. It includes a snap on/off cover over the SD Card to make it easy to access and an internal guard around the microphone to cut down on wind noise.

Versions

The three versions are shown below. They all use the same top cover.

You will need to have an M3 tap to set-up the top and bottom.

Print Parts

Image	Part Number	Part Description	Weight	Print File	Drawing	Compatibility
	52067	RunCam Split PCB Top Cover	6g	52067.STL	52067_Sketch	Fits RunCam Split V1
	52076	RunCam Split SD Card Snap Cover	6g	52076.STL	52076_Sketch	Fits 52067 Cover.
	52086	RunCam Split PCB Cover Bottom, Extended Mount	6g	52086.STL	52086_Sketch	Fits RunCam Split V1
	52087	RunCam Split PCB Cover Bottom, Integrated Mount	7g	52087.STL	52087_Sketch	Fits RunCam Split V1
	52088	RunCam Split PCB Cover Bottom, Standard Mount	7g	52088.STL	52088_Sketch	Fits RunCam Split V1

See Also

TBA

Project 3D Print Files

This project can also be found on Thingiverse - [1]

<u>email me!