Difference between revisions of "Mini Talon X-UAV from FPV Model"
(→Build/Layout) |
(→Maiden) |
||
| Line 133: | Line 133: | ||
<br><br><br> | <br><br><br> | ||
| − | [[Category:Contents|Talon_X-UAV_from_FPV_Mode | + | [[Category:Contents|Talon_X-UAV_from_FPV_Mode]] |
[[Category:Planes]] | [[Category:Planes]] | ||
Revision as of 20:12, 17 January 2016
January 2016
| |
| Ready for fun! |
Introduction
Decided to try the Mini Talon as a way to get a medium range plane I could easily throw in my car. I looked at the Twin Star and the Floater Jet but finally decided on the Mini Talon because my large Talon is such a great flyer and it is relativley inexpensive.
Airframe and Controls
I did decide to try a set of Digital servos mainly because I had them already. The linkage was changed to small Dubro 2-56 ball-ends on the Elevons because of the high miss-allignment btween the controll surface and the sevo arm travel.
|
| Ball-end linkage on the elevons |
For this build, I decided to try an RTFQ ReadyToFly 2.8 flight controller to save a few bucks and check out if they are reliable and as easy to set-up as my APM. I am using APMPlane 3.3 firmware.
For an OSD, I am running an RTFQ MicroMinium OSD with my own character set.
For radio gear I am using DragonLink V2 with the MicroRX Copter receiver.
Specifications
Build date - January 2016
All Up Weight (no battery) - 1,314g (47oz)
Weight with 8,000mAh pack - 1,955g (69oz)
Wingspan - 1,300mm (51 inches)
Motor - Cobra 2221/16 - 940Kv
ESC - Cobra 33A
Battery - 8,000mAh Zippy Compact
Propeller - APCe 9 x 6 or Aeronaut 9.5 x 6 folder
Build/Layout
I won't spend anytime on pictures of assembling/gluing the foam bits together. I'll just show any mods and/or custom setups I did for this build. This starts with a simple layout with the Flight controller mounted on a plywood plate with rubber dampers attached between the wing support plates.
|
| Flight Controller mounted on plywood plate with Micro MinimOSD servo taped to the top of the case |
|
| Layout showing the Flight Controller, Micro MinimOSD, FPV power module and GPS |
On the front I built an "FPV" module which includes the VTx, DL 1,3G Dipole antenna, a Storm32 brushless gimbal control board, an Effio camera, a three axis gimbal and a two way camera switch.
|
| FPV module showing the DragonLink 1.3G Dipole antenna |
|
| FPV module - Bottom view with VTx aluminum shield and heatsink |
To power the FPV module I printed a mount plate for a 12v regulator, a 5v regulator and an RMRC LC power filter. All three components are mounted on foam tape with wire ties to hold them down.
|
| FPV Power Module |
|
| Power module schematic |
FPV Module views
|
| Side view with VTx antenna |
|
| Front view |
Maiden
When I get it done and written i will surely post it!
